Welcome to Test-paper.info
Friday, January 19 2018 @ 11:09 PM CST
 Select a Forum » General Chat » Primary 1 Matters » Primary 2 Matters » Primary 3 Matters » Primary 4 Matters » Primary 5 Matters » Primary 6 Matters » Question, Feedback and Comments » Education Classified
 Forum Index >  Test Paper Related >  Primary 6 Matters Question on area/perimeter of circles
 | Printable Version
 By: keenlearner (offline)  Thursday, December 20 2012 @ 09:19 AM CST (Read 933 times)
keenlearner

The figure in attachment is made up of 3 circles with the same radius 10cm.
X, Y and Z are the centres of the circles respectively. For each of the following, use the calculator value of 'pi" to find.

(a) the perimeter if the shaded parts, correct to 2 decimal places. (Ans: 83.78cm)

(b) the area of the shaded parts, correct to 2 decimal places.(Ans: 209.44cm2)

Junior

Registered: 11/08/12
Posts: 22

 By: echeewh (offline)  Thursday, December 20 2012 @ 06:26 PM CST
echeewh

Hey keenlearner,

I think you have missed out "pi" in the following statement (quoted from your question) :

For each of the following, use the calculator value of to find.

It should read as (if I am correct) :

For each of the following, use the calculator value of "pi" to find.

-----------
Pls note it will be better if you can also provide the Answerkey to your question , where applicable.

Kindly refer to the attached document for my worked solution, and do let me know again if this is different from your Answerkey or if there's further clarification.

Cheers,
Edward

NOTE: My apologies to all readers. Worked solution was posted as at 22/12 , 7.20am.

Active Member

Registered: 04/21/11
Posts: 627

 By: keenlearner (offline)  Friday, December 21 2012 @ 04:49 AM CST
keenlearner

Hi Edward,

Thanks for pointing out the typo error. I am not able to see your work solution in the circles attachment. Cheers.

Junior

Registered: 11/08/12
Posts: 22

 By: echeewh (offline)  Friday, December 21 2012 @ 05:16 PM CST
echeewh

Hi keenlearner,

Thank you for letting me know that the worked solution was not properly attached earlier.

The worked solution has now been posted.

Best regards,
Edward

Active Member

Registered: 04/21/11
Posts: 627

 All times are CST. The time is now 11:09 pm.
 Normal Topic Locked Topic Sticky Topic
 New Post Sticky Topic w/ New Post Locked Topic w/ New Post
 View Anonymous Posts Able to Post HTML Allowed Censored Content